d8b Forum

Hi

yes it is possible to damage that it such a way, but normally These cable are quite robust.

Additional in your case i think the problem might be the cable that is goint from the brain to the sub-d25 pol connector on the back. I think you have not touched it.

Anyhow, it is is not that difficult to make such a cable by yourself. You do not have to solder, it is a simple "click -in" System.

Hi munk

Thanks for ur help. I took the power distribution card out and made sure all the cables on there was reseated
Is this what ur talking about. I also checked the data cable and replaced it with a new one. I just happen to remember that my d8b booted up and ran for about half hour then it would freeze but all the light was on until I went in thee and reseated the ribbon cables After that I could not get my d8b to boot up or get any LEDs to light up only the rud solo light would come on. That's why I was asking about the ribbon cables. I had to do something wrong but don't know what.

Joe allen

maybe you can post a high Resolution Picture of your opened d8b, so we can check if all cables are seated in the right plugs. Or maybe we see something different tht may be important

best regards

Check these out just in case

Phil

Thanks for the pictures Phil and
Tomorrow I will look to make sure all my ribbon cables are all the
Same as the ones in the pictures you sent Then I will see I give can get
My girl to take some pictures and send them as munk said to do maybe someone
Can see if there all I place. I just hope my girl knows how to send pictures I have never done
That before so I am lost maybe she can. Thanks again for every ones help

Joe allen

yes you can send it to me if you want. PM me for the email address.

best regards
Munk

Hi munk

Did you get my pm

Joe Allen

Hi munk

Have you had a chance to look at the LEDs on the brain board video that I sent you
No rush I was just wondering I hope I can get it fixed and worked out its been a long time since
My d8b has been down. It seems like a long time anyway. Thanks for your time next help munk

Joe allen

Hi Joe

i check that with my d8b today evening
best regards

Thanks munk for all your help

Joe allen