help me to bring my d8b back to life

[Eddos]

Hello everyone!

A week ago a bought a d8b from a old member from this forum, he had some problems with the faders he said.
The problems he had did he write in the post down below.

http://www.d8bforum.com/phpBB3/viewtopic.php?f=2&t=1039&p=8372#p8372

and

http://www.d8bforum.com/phpBB3/viewtopic.php?f=6&t=1038&p=8211#p8211

I was a little bit worried for the broken rail cap where everyone talks about, so i opened the d8b myself and looked to the brainboard and the 3 other boards where the faders are attached. i see nothing burned or oxidized. The looked almost brandnew!



So i looked further and i saw something maybe suspicious in the computerbox.
I think it has something to do with the power supply?







I see a lot of toxication and rust on that thing

hopefully someone can confirm this.

Thanks for helping me out!

[Phil.c]

I'm no expert but it looks like a couple of dry joints, maybe causing arcing, re-solder and see what happens.

Phil

[Eddos]

Thanks for the reply phil,

Going to give it a shot later

I looked to the rail cap braiboard and it looks oke to me.

[the boss]

Hi

I've repaired 6 of those d8b's and my conclusion is that over the years that 5v 22amp switched psu starts to get unstable.... that's why we all get strange symptoms.

Re place it....

I just wish that someone could find a psu to replace it with. I've tried a standard 5v 30 amp and yes it boots up but all lights is on and it freezes..... so I had to get a identical one from another CPU/ PSU d8b box

[the boss]

There is that small wire connected to the switched psu.... a sensor .... this one tells when the switched psu should turn on and off and so on.... that's why it doesn't work with a standard switched psu 5v 30 amps

[the boss]

All other stuff in the PSU/ CPU is easy to re-place. You can get old motherboards from eBay and even replace it with a different one.... I've done it several times.... it takes 30 minutes. You just have to know what you've doing otherwise it will burn out.....

[the boss]

I've got a new motherboard for you and also a braincard and some faders..... all this is easy to replace.

[Eddos]

Thanks for the feedback boss

Can you make a picture for me?
Where is that 5v switch located?

[Van]

image.jpg (Array MiB) Viewed 1441 times

Can anyone help me with this error

[Jondav1120]

Hello Van,

Are you also getting 'Error 43 - host did not boot' on the console display? Looks like there is no communication between the host computer and the console. Check the connections on the data cable or try another cable.
Could also be caused by BIOS settings, try checking the BIOS settings against the database http://www.sonido-7.com/d8b/maintenance.html#Post1

Regards

John