Change font size   Print view

external word clock sync issue.

Discussion board for Mackie's d8b Digital Console users.

external word clock sync issue.

Postby Tim Nighitngale » Mon Feb 06, 2017 2:28 pm

HI Guys. I am new to this board. I am a Mackie service centre in sheffield(england) and have had a client bring in a d8b that I cannot get to lock to the external word clock (fixed everything else - now tearing my hair out - well whats left of it)

I have stripped the boards out, cleaned them, cleaned the ribbons and the connectors and tested them all. My client has brought me his DCS verona clock generator in case it was my clock generator that was faulty.
I have tried removing the termination resistor and re fitted the termination resistor on the apogee card.
Fitting a terminator to the bnc output.
We also tried his spare apogee card.

the unit is fine in internal clock mode and apparently will lock to his external source through his optical card but not through the apogee card.

So here are the questions.
1 does anyone have a copy of the apogee card schematic? (I spoke to Apogee but they said they don't give out schematics and it is an unsupported product).

2 if not does anyone know how the clock source is physically switched on the card.

3 am I just missing something so basic and obvious as a tick box somewhere.

Any help / suggestions gratefully received.

Tim
Tim Nighitngale
Registered user
 
Posts: 2
Joined: Mon Feb 06, 2017 2:04 pm

Re: external word clock sync issue.

Postby Petersueco » Mon Feb 06, 2017 8:19 pm

Hello Tim.
Welcome to the forum.

There is a section in the Database that could give some hints about word clock in the d8b.

http://www.sonido-7.com/d8b/wordclock.html

I hope you find what you are looking for.

Good luck.
Sonido 7
Music Production Studio
User avatar
Petersueco
Site Admin
Site Admin
 
Posts: 581
Joined: Fri Nov 21, 2008 5:25 pm
Location: Marbella - Spain

Re: external word clock sync issue.

Postby Tim Nighitngale » Tue Feb 07, 2017 5:09 pm

Hello again.

A little more probing and stabbing things with a scope probe and such.

When running in internal mode the clocks on the back plane and on the output of the apogee card run at 44.1K.

Switch it into word clock and the clock runs at about 57K and oddly it won't lock.

If I unplug the wordclock from the desk the output clocks sweep between about 27K and 57K.

Is it possible to re-install the apogee software and where would I find this?

Once again any help
Tim Nighitngale
Registered user
 
Posts: 2
Joined: Mon Feb 06, 2017 2:04 pm

Re: external word clock sync issue.

Postby Crash » Tue Feb 07, 2017 6:47 pm

There is no "Apogee" software to run. Any chance you are using a bad BNC cable?
User avatar
Crash
Premium Member
Premium Member
 
Posts: 1281
Joined: Fri Nov 21, 2008 10:05 pm


Return to d8b Forum

Who is online

Users browsing this forum: Phil.c and 5 guests

cron