Page 1 of 1

Error 43: Host did not boot..smh

PostPosted: Tue Aug 29, 2017 7:05 pm
by NoeltheEngineer
Hello,

Im having issues with my d8b. I had it for a few years and it never gave me problem until recently. I went ahead and did some reseach and set my BIOS, CMOS, INTERGRADED PERIPHERAL ect. back to recommended settings. I even replaced the motherboard battery then clean and reseated all my card on the board and cpu. Is there anything else I can do before I donate this board to the wind?


cpu error: Control Card not ready. Last Known State:Reset
Board Error: Error 43. Host did not boot

Re: Error 43: Host did not boot..smh

PostPosted: Tue Aug 29, 2017 9:37 pm
by Crash
Try reinstaling the software for giggles.

Re: Error 43: Host did not boot..smh

PostPosted: Thu Aug 31, 2017 1:24 pm
by NoeltheEngineer
Thank you. Ill give it a shot and ill let you know if that did the trick

Re: Error 43: Host did not boot..smh

PostPosted: Thu Aug 31, 2017 6:12 pm
by Crash
Another thing that can cause strange oddities is wonky RAM. You might try reseating that or trying new RAM as well.

Re: Error 43: Host did not boot..smh

PostPosted: Fri Sep 01, 2017 10:40 pm
by salvaes
This is to blame for most problems that the table does not respond properly.

Clean with clean electronic contacts.
and try again