d8b Forum

The only ways I can think of to clock to an outside system is with BNC connection on the Apogee clock card or through light pipe via ADAT optical. I pulled this from a manual somewhere in regards to the BNC connectors on the DIO8 cards.

In addition, it has a BNC connector, which provides a DTRS clock output for devices
that require it. The DTRS clock is the same frequency as the word clock, but is 90 degrees out of
phase with the standard word clock.

If you can get the Red rig to sync to that... ?

Hi
It is very strange , but it has worked with this upset since
i got it.

verner wrote:Hi
It is very strange , but it has worked with this upset since
i got it.

My guess is that the issue is on the RED side. There are more variables on clocking than there are on the d8b.

Synk upset in red24 “TDIF A”

I looked through the pics, I am not familiar enough with the RED setup to be of much help. Your life would be easier if you had an Apogee clock card installed on the d8b but I know they are hard to find these days.