True balanced output?

[Casey_Pittman]

Those video's are relevant in that that is the exact method I'm using just with a d8b. Yes some of the connections are different and I've had to adapt to what I have on hand, but essentially the same.

I'm using a TRS out of the AUX sends and the BUS outs are TRS as well(db25->TRS).

The signal probe IS TS. Nothing plugs into the signal probe. I realize that that might be where the confusion is coming in as far as the diagram goes. The diagram is shit, lets forget the diagram.

Nothing plugs into the Signal probe. The signal probe plugs into either an amp or back into a channel on the board so you can hear the tone that is being sent out the AUX and BUS outs. Now in order to hear the tone from those outputs you connect the alligator clips(ground) to the sleeve(ground) of the cable coming from the AUX/BUS and you touch either the Hot(tip) or the cold(ring), of the same cable, to check to see if there is signal present on both pins. In a truly balanced signal you WILL hear the tone coming from both the tip and the ring.

I've done it using a different interface, I'm not crazy.

-Casey-i'm going grey-Pittman

[anyhorizon]

I didn't say you were crazy, it's just that following the sequence of events has been hard. I have a feeling that although differential is of a balanced nature and Common Mode Rejection works, the cold doesn't show any signal. Rivers would be able to answer this.

Peter

[anyhorizon]

Well, how quickly we forget! Here's your answer, halfway down the page where Mike gives me a serve.

Not differential

Sorry 'bout the confusion.

Peter

[Casey_Pittman]

I know you didn't and I didn't mean to imply that you did. It was more of "keep telling yourself that" moment.

Holy hell there is my answer. Yay I'm not crazy....I just prefer differential to impedance balanced outputs. Makes me feel like I'm not getting jiped no matter what the math says.

Mystery solved I guess. And technically they are balanced.

Thanks for the help and for bearing with me Peter & David.

-Casey

[High C Double G]

Thanks for the help and for bearing with me Peter & David.

-Casey

Hey what about me??? do you know how hard it is to solder a DB25 connector!!! ??

And they call me unbalanced!

HA!

[FrankH]

images.jpg (Array KiB) Viewed 955 times